Advanced Search
Search the Knowledgebase
| Author: Microengine Views: 7659 Created: 04-02-2016 03:43 PM | 0 Rating/ Voters |
 |
This article contains wiring connection diagram of XP-M1000x to solve issue door is not release when fire alarm is triggered.
Applies To:
- XP-M1000x, XP-M1000ABX, XP-M1300X, XP-M1300ABX, XP-M1000XE, XP-M1000CPX
Problem Symptoms Cause (optional) Resolution Summary ResolutionPlease complete the following steps to solve the issue.
For high resolution image, please download the attached wiring diagram at the end of this article.
Fire Alarm Panel
- Please connect the Fire Alarm Panel to the GPIO port at MAS-RBU correctly.
Fire Alarm Lock Release
- Please enable the Fire Alarm Lock Release door parameter from the controller. If your controller is connected to the software, make sure the controller status is "Up" before you proceed.
- To edit the door parameter setting, please follow steps below:
- Enter
Programming Menu. - Press '1' for Sys Menu.
- Press '2' for Door Para. The screen below will be displayed.
- Press '#' to proceed to the next item until "FireRls [OFF]" page is displayed.
- Edit the values for the item displayed to [ON] by pressing '0' to toggle between settings.
- Press '#' to proceed to the next item.
- Continue doing this until the Save Changes page is displayed.
- Press '#' to save changes and exit from the Door Parameter setting.The changes will not be saved if the configuration is interrupted midway.
Custom Fields
- Summary: This article contains wiring connection diagram of XP-M1000x to solve issue door is not release when fire alarm is triggered.
- Search Tags: wiring connection diagram, fire alarm trigger, door parameter, fire alarm lock release
Comments
-
There are no comments for this article.
Submit Feedback on this Article
