Knowledge Base

› How can I know the AntiPassBack/ CardLockOut is enabled? 
› Which symbol to determine the controller is in Higher Security Mode (Card+PIN mode)?  
› How can I know the controller’s security is turned on/ off?
› Which symbol is to determine the controller’s uplink/ downlink is established?

Refer to the table description below for the meaning of symbol on XP-GT/GTR controller.

Field	Description
AntiPassBack	AntiPassBack Mode enabled. Once enabled, the user will not be able to use the same card to gain access through the same direction repeatedly without gaining access on the opposite direction.
CardLockOut	CardLockOut Mode enable. Once enabled, the token will be locked permanently after failure to gain access for three consecutive times. The failure might be caused by wrong pin number, wrong time zone or anti pass back violations.
Higher Security  (Card+PIN)	In Higher Security Mode, users need to enter the comply to the pre-set verification mode after to gain access. This provides higher security.  How do I change controller's verification mode to Card+Pin mode at software?
Security On	Security Mode enabled. Users must adhere to the verification mode settings to gain access.
Security Off	Security Mode disabled, which will cause the lock to be permanently released.
Uplink Communication	Communication has been established with the remote server to allow the sending and receiving of data when this icon is blinking.  I have just installed a new XP-GT/ XP-GTR controller but it shown down in Device List (Lock is not respond – Uplink failed)
Downlink Communication	Communication has been established with the relay board when this icon appears.  I have just installed a new XP-GT/ XP-GTR controller but it shown down in Device List (Lock is not respond – Downlink failed)