XP-M1000X

Knowledge Base
Advanced Search Search the Knowledgebase
Knowledge Base
There are no subcategories in this category.
1 How to reset the reader/ controller to factory default setting? (Coldstart) Featured

This article contains steps to reset the reader/ controller to factory default setting (Coldstart).

2 List of wiring connection diagram for the controllers Featured

This article contains the list of wiring connection diagram for the controllers.

3 Wiring connection for XP-M1000x using RS485 connection Featured

This article contains steps to connect XP-M1000x reader using RS485 connection.

4 Basic new setup (connection, controller, and door(s)) using xPortal3000 wizard

xPortal3000 provided Startup Wizard to setup Door Access System easily. This article contains steps to setup new connection, controller and door(s) using the wizard.

5 Configuration Setup for XP-M1000x (Car Park Mode)

This article contains the configuration setup for XP-M1000x using Car Park Mode.

6 Door is not release after received Fire Alarm Signal from the master controller

This article contains steps to solve problem when door is closed after received Fire Alarm Signal.

7 Double leaf door is not release/ 1 door only release

This article contains wiring connection diagram of XP-M1000x for double leaf door to solve the issue door is not release.

8 Fire alarm triggered but door is not release

This article contains wiring connection diagram of XP-M1000x to solve issue door is not release when fire alarm is triggered.

9 How do I change the XP-M1000x as Exit reader while XP-RDPRX as Entry reader?

This article contains steps to change the XP-M1000x as Exit reader while XP-RDPRX as Entry reader.

10 How do I change the XP-M1000x controller to Card+Pin mode?

This article contains steps to change the XP-M1000x controller's verification mode to Card+Pin mode.

1 2 3 4 Next