Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
"Enrolment of Mifare card failed!"
Author: Microengine Views: 11935 Created: 29-01-2016 02:00 PM 0 Rating/ Voters

This article contains solution of "Enrolment of Mifare card failed".

Applies To:

  • XP-Plato C80KLs, Mifare Card
  • Software xPortal3000

› Accidentally lift up the Mifare card from the Programming Reader during the writing process and getting error message.
› Unable to proceed with the current card enrolment.


› Error message as shown below will be shown.

 Cause (optional)

› This error is shown because the Mifare card is not properly place on the programming reader during the card programming. 
› The programming reader unable to detect the Mifare card during the enrolment process.



Please perform the following steps to solve the issue above.

  1. Click OK to dismiss the error message.
  2. Click Restart for Fail Cases button. 
  3. The software will prompt to place the next card.
    User cannot resume with the same Card No (which it current status is Fail) because "Halt processing if exception trapped" option is unchecked. User can only write current failed card after all records in the list has completed the card programming process.
  4. Please place the card properly on the programming reader.
  5. Please do not lift the card until the enrolment is complete and success.
    This steps can only be performed if the small Halt processing if exception trapped option is unchecked. If it is checked, see small "The bulk write card task has been halted due to error!".

Custom Fields
  • Summary: This article contains solution of "Enrolment of Mifare card failed".
  • Search Tags: enrolment of mifare card fail, lift up the mifare card from the programming reader during the writing process, enrolment of mifare card failed
  • There are no comments for this article.
Submit Feedback on this Article