Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to configure Instruction Control for Input to trigger Output?
Author: Microengine Views: 12004 Created: 05-11-2015 05:20 PM 0 Rating/ Voters

This article contains the steps to configure the Instruction Control for Input to trigger the Output.

Applies To:

  • XP-SNET v3.48 and above, XP-CPROA 
  • Software xPotrtalNet v1.5    
 Resolution Summary
 

Instruction Control: Configuration for Input and Output triggering.

  1. Please ensure the Input and Output is already configured.
  2. Then, configure the Instruction Control from the xPortalNet Client.
  3. After completed the configuration, please donwload the Door Settings to the controller.
 Resolution
 

Perform steps below to configure Instruction Control.


Please ensure the Input and Output is already configured before proceed.

  1. Login to xPortalNet Client.
  2. Open Instruction Control. Go to Data Setup › System Setting › Instruction Control.
  3. Add new instruction control.


    Fill in the fields:
    FieldDescription
    Code and DescriptionFill in the Code and Description
    Event IDSelect unique Event ID for this instruction
    Group NoSelect unique Group No for this instruction
    ControllerSelect which controller that is connected to the input and output
    Alarm PrioritySelect the alarm priority when the event is triggered
    Input Source GroupClick Add Input to select the Input

    Group Operator
    • AND ModeIf all Inputs is triggered at the same time, the Outputs will be ON 
    • OR ModeIf any Inputs is triggered, the Outputs will be ON

    Outputs
    • Click Add Output to select the Output
    • If this message is showing, click OK.
  4. Click OK to confirm and save settings.
    Maximum Input and Output can be added in 1 Instruction is 8. Repeat this steps to add another Instruction.

  1. After finish configuring all settings, please download the Door Settings to the controller.
  2. Open Send Door Settings. Go to Device Comm › Send Door Setting.

  3. Finished.
Custom Fields
  • Summary: This article contains the steps to configure the Instruction Control for Input to trigger the Output.
  • Search Tags: instruction control, how to trigger output, setup instruction control, input, output, group operator, event, instruction, alarm trigger
Comments
  • There are no comments for this article.
Submit Feedback on this Article