Knowledge Base

1. Connect the output at the correct relays number. There are 8 relays reserved for the Output on the board.
   
   
   
2. If settings configured is for (Door Access + Alarm Mode), please refer table below for output configurations.
   

   Field	Description
   Output Relay 1 - 5	Output for Door, which can connect to EM Lock. Only can be triggered by IN1 - IN10 (Door Sensor and Push Button)
   Output Relay 6 - 8	Extra output relay. Only can be triggered by IN11 - IN16 (Extra Input)

   
   
3. If settings configured is for (Alarm Mode), please refer table below for output configurations.
   

   Field	Description
   Output Relay 1 - 8	Only can be triggered by Sensor Input IN1 - IN16

Alarm Controller Setup

1. Login to xPortalNet Server.
2. Open Alarm Controller Setup. Go to Server Admin › System Device Setup › Alarm Controller.
3. Add one alarm controller.
   
   
   Please select the correct Model No according to the installed alarm controller. If not connected to any alarm controller, set the Model No to Built-In IO.
4. Click OK to confirm and save settings.

Output Point Setup

1. Open Output Point. Go to Server Admin › System Device Setup › Output Point.
2. Add output point according to the connected output at the controller board.
   
   

   Field	Description
   Code and Description	Fill in the Code and Description
   Alarm Controller	Select Alarm Controller
   Point No	Set the Output Point - Which relay (RLY) the output is connected to. Example: If Output is connected to RLY2, set the Point No to 1. The Relay Point No start from 0 until 7.

3. Please leave the Event Trigger On and Off blank. 
4. Click OK to confirm and save settings.
   
   Input/ output triggering for XP-SNET/ XP-CPROA, see  How to configure Instruction Control for Input to trigger Output?

1. Open Send Door Settings. Go to Device Comm › Send Door Setting.
2. Download the Alarm Controller and Outputs settings to the controller.
   
   
   
3. Finished.
   
   To configure Input, see  How to configure Input?