Advanced Search
Search the Knowledgebase
| Author: Microengine Views: 25778 Created: 27-10-2015 06:07 PM | 0 Rating/ Voters |
 |
This article contains steps to configure the address setting for Multi-Door Controller.
Applies To:
- XP-M1000i, XP-M2000i, XP-CPRO, XP-SNET
Resolution Summary Resolution
Perform steps below:
Address Setting
Controller Setup
Address Setting
- Please check the wiring connection is correct before proceed.
Field Description XP-SNET Wiring connection diagram for XP-SNET XP-M2000i Wiring connection diagram for XP-M2000i XP-M1000i Wiring connection diagram for XP-M1000i XP-CPRO Wiring connection diagram for XP-CPRO - Follow steps below to configure address for controller.
- Refer to the image below to set the address setting from the controller board.
- Toggle the dip switch correctly.
- Example: Address 01 - Toggle Up No 1 and Toggle Down No 2,3,4.
Controller Setup
- Login to xPortal Server.
- Open Controller Setup. Go to Server Admin › Controller Setup.
- Refer to the image below to set the address setting of the controller at the xPortal software.
- Set the Unit No according to the Address Setting you have set from the controller board.
Example: - Dip switch = 00, Unit No = 0
- Dip switch = 01, Unit No = 1
- Dip switch = 02, Unit No = 2
Each controller must have unique address no.
Custom Fields
- Summary: This article contains steps to configure the address setting for Multi-Door Controller.
- Search Tags: configure address setting, dip switch, unit no, controller board, multi-door controller, many door, set address
Related Articles
Comments
-
There are no comments for this article.
Submit Feedback on this Article
