Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to configure Date Checking feature using XP-SNET v4?
Author: Microengine Views: 7727 Created: 21-09-2015 06:20 PM 0 Rating/ Voters

This article contains the configuration setup for Date Checking feature using XP-SNET v4.  

Applies To:

  • XP-SNET v4
  • Software xPortalNet
 Resolution Summary
 
Date Checking feature is used to validate the card whether the period of the card activation is still valid to be use or invalid. If invalid, user shall be not able to access the door using that card.

However, using XP-SNET v4, there will be extra checking as the controller can support up to 5 Door Accessibility. There will be conditional checking on the Validity of Access (001/000) and Validity of Date (Start Date & End Date) which will allow user to get "Valid Access"/ "Wrong Time Zone"/ "Door Access Expired" transactions.

User can enable the settings from Door AccessibilityStart Date/ End Date

 Resolution
 

Please perform steps below to enable the Date Checking feature.

This feature is only applicable to XP-SNETv4 controller model

  1. Run xPortalNet Client.
  2. Open Door Accessibility. Go to Data Setup › Access Data Setting › Door Accessibility Schedule.
    To configure Door Accessibility, see article small How to configure Door Accessibility in xPortal Client software?
  3. During the configuration, at Start Date and End Date field:
    1. Tick the checkbox.
    2. Set the preferred Start Date & End Date (Card activation's period)


  4. Click OK to confirm and save the changes.
  5. Assign the door accessibility to the staff accordingly.
  6. Flash card to verify the settings has been saved correctly.
  7. User shall get outcome as shown in the following table based on several conditions checking:
    Condition shown in the table is applicable to 5 door access. If you are using only 1 door access, ignore the other door accessibility. Transaction will be shown according to the matched condition.
  8. Transaction will show "Valid Access":
    » If
    either one pair Valid Access + Valid Date
    Door Accessibility Condition
    DA #1 Valid Access + Invalid Date
    DA #2 Invalid Access + Valid Date
    DA #3 Valid Access + Valid Date
    DA #4 Valid Access + Invalid Date
    DA #5 Valid Access + Invalid Date

  9. Transaction will show "Wrong Time Zone":
    » If
    all pair Invalid Access
    Door Accessibility Condition
    DA #1 Invalid Access + Valid Date
    DA #2 Invalid Access + Invalid Date
    DA #3 Invalid Access + Valid Date
    DA #4 Invalid Access + Valid Date
    DA #5 Invalid Access + Invalid Date

  10. Transaction will show "Door Access Expired":
    » If
    either one pair Valid Access + Expired Date
    Door Accessibility Condition
    DA #1 Invalid Access + Invalid Date
    DA #2 Invalid Access + Valid Date
    DA #3 Invalid Access + Valid Date 
    DA #4 Invalid Access + Valid Date
    DA #5 Valid Access + Invalid Date
Custom Fields
  • Summary: This article contains the configuration setup for Date Checking feature using XP-SNET v4.
  • Search Tags: date, checking, configuration, xp-snet, v4
Comments
  • There are no comments for this article.
Submit Feedback on this Article