Knowledge Base

Please perform steps below to enable the Date Checking feature.

This feature is only applicable to XP-SNETv4 controller model

1. Run xPortalNet Client.
2. Open Door Accessibility. Go to Data Setup › Access Data Setting › Door Accessibility Schedule.
   
   To configure Door Accessibility, see article  How to configure Door Accessibility in xPortal Client software?
3. During the configuration, at Start Date and End Date field:
1. Tick the checkbox.
2. Set the preferred Start Date & End Date (Card activation's period)
   
   
   
4. Click OK to confirm and save the changes.
5. Assign the door accessibility to the staff accordingly.
6. Flash card to verify the settings has been saved correctly.
7. User shall get outcome as shown in the following table based on several conditions checking:
   
   Condition shown in the table is applicable to 5 door access. If you are using only 1 door access, ignore the other door accessibility. Transaction will be shown according to the matched condition.
8. Transaction will show "Valid Access":
   » If either one pair Valid Access + Valid Date
   

   Door Accessibility	Condition
   DA #1	Valid Access + Invalid Date
   DA #2	Invalid Access + Valid Date
   DA #3	Valid Access + Valid Date
   DA #4	Valid Access + Invalid Date
   DA #5	Valid Access + Invalid Date

   
   
9. Transaction will show "Wrong Time Zone":
   » If all pair Invalid Access
   

   Door Accessibility	Condition
   DA #1	Invalid Access + Valid Date
   DA #2	Invalid Access + Invalid Date
   DA #3	Invalid Access + Valid Date
   DA #4	Invalid Access + Valid Date
   DA #5	Invalid Access + Invalid Date

   
   
10. Transaction will show "Door Access Expired":
    » If either one pair Valid Access + Expired Date
    

    Door Accessibility	Condition
    DA #1	Invalid Access + Invalid Date
    DA #2	Invalid Access + Valid Date
    DA #3	Invalid Access + Valid Date
    DA #4	Invalid Access + Valid Date
    DA #5	Valid Access + Invalid Date