Advanced Search
Search the Knowledgebase
| Author: Microengine Views: 16438 Created: 15-06-2015 10:24 AM | 0 Rating/ Voters |
 |
This article contains the wiring connection diagram for XP-SR1000.
Applies To:
- XP-SR1000
Resolution Summary ResolutionPlease complete the following steps below.
Refer to the attached wiring diagram at the end of this article for best view.
Configure the wiring connection according to the following wiring diagram.
- Please check the connection to PC using Network/ RS485 is correct. Refer figure below.
- Check the TTL reader is correctly connected. Refer figure below.
- Power ON the reader by connect it to a power supply with 12Vdc, 3A.
- Make sure the terminal output from MAS-RB to lock is producing correct voltage level.
- To measure the voltage level at terminal output of MAS-RB, connect the Multimeter's Red Probe to the L/NC and Black Probe to the L/RET.
- When door security status is ON, the EM Lock should be in locked condition.
» The voltage measured at terminal L/NC and L/RET showed is about 12V (±10 %) - When door security status is OFF, the EM Lock should be in unlocked condition (Door released).
» The voltage measured at terminal L/NC and L/RET approximately +12Vdc (±10 %)
| Help Desk Software by: KnowledgeBase Manager Pro v6.2.2 (Built with: JS.GUI - AJAX Tool) |
Custom Fields
- Summary: This article contains the wiring connection diagram for XP-SR1000.
- Search Tags: wiring diagram xp-sr1000, drawing, xp-sr1000 wiring, mas-rb, mas-rb2
Related Articles
Comments
-
There are no comments for this article.
Submit Feedback on this Article
