Knowledge Base

Configuration setup: 

1. Configure the Network Setting from the Web Diagnostic.    
2. Configure the Connection, Controller and Door setup from the xPortalNet Server.
3. Observe the Device Status from the Device List to confirm communication is Up between controller and software.
   

Please follow the following steps to configure network connection for XP-SNET controller: 

Check the wiring connection first before proceed. See  Wiring connection diagram for XP-SNET.

1. Add new connection. 
2. Open Connection Setup. Go to Server Admin › Connection Setup.
3. Fill up the fields boxed in red color.
4. Remote IP Address is the controller's IP Address (Configured at Web Diagnostic › Network Setting › IP Address)
   
   
5. Click OK to confirm and save the settings.

1. Add new controller. 
2. Open Controller Setup. Go to Server Admin › System Device Setup › Controller.
   
   
   
3. Select the correct  Connection,  Unit No, Model No and the Network Type.
4. Click OK to confirm and save the settings.

1. Add new door. (Entry and Exit included for each door)
2. Open Door Setup. Go to Server Admin › System Device Setup › Door.
3. Set the correct Unit No. See  How to configure address setting for XP-SNET reader?
   
   Eg: Directly connect to (CON32 as entry, CON33 as exit)
   
   
   Connected to MK800:
   
   
   
4. Click OK to confirm and save the settings.

1. The software will be reloaded after saving each setup. Observe the Device List. 
2. The controller and door status should already "Up".