Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How can I use Card+Pin Mode for XP-M1000i controller?
Author: Microengine Views: 30078 Created: 30-04-2015 05:58 PM 0 Rating/ Voters

This article contains steps to apply Card+Pin Mode for XP-M1000i controller.

Applies To:

  • XP-M1000i
  • XP-M2000i
  • P80KL
  • Software xPortal2005 v1.3
  • Software xPortalNet
  • Software xPortal3000

 Problem
 

› I want to use Card+Pin Mode for my door access. How to configure the setting?   

       
 Resolution Summary
 
Card+ PIN Mode configuration:

Hardware configuration
› Make sure the XP-M1000i is connected with P80KL reader.

Software configuration
         
 Resolution
 

Perform this steps to configure Card+Pin Mode for door access.

Hardware configuration:

  1. Make sure the XP-M1000i is connected with P80KL reader. 
  2. Otherwise the Card+Pin Mode cannot be used using this controller.


  3. Connect the P80KL to the RC- and RC+ terminal. 



Software Configuration:

Login to xPortal Client software.

Staff Records Setup:

  1. Add staff record. (Go to Data Setup › Access Data Setting › Staff Records)
  2. Make sure "Verification Mode" selected is By Door.


  3. Click OK to confirm and save settings.



Door Setup:

  1. Open Door Setup. (Go to Data Setup › System Setting › Door)
  2. At Higher Security Mode, please select Token Type + PIN.
  3. At Higher Security TZ*, please select 001
    1. You may also create your own Higher Security TZ. See AA-00277.

      » 001 Time Zone will required all staff to present card and enter PIN at all time whenever they accessing the door.

  4. Click OK to confirm and save settings.

Custom Fields
  • Summary: This article contains steps to apply Card+Pin Mode for XP-M1000i controller.
  • Search Tags: card+pin mode, xp-m1000i, add card
Comments
  • There are no comments for this article.
Submit Feedback on this Article