Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to set verification mode is using fingerprint only for door access?
Author: Microengine Views: 13478 Created: 27-03-2015 05:07 PM 0 Rating/ Voters

This article contains steps to use Verification Mode "Fingerprint Only" for door access.

Applies To:

  • XP-GT1200L/ XP-GT3200L
  • XP-GT1200LABX/ XP-GT3200LABX
  • XP-GT3200LE
  • XP-GT3200LCPX
  • XP-GT500LE
 Problem
 

› How to set Verification Mode finger print only?          

         
 Resolution
 

Perform this steps to configure door access using finger print only:

  1. If add staff at Controller (standalone controller, not connected with software):
    1. See AA-00314 to add new staff at controller.
    2. You may select your preferred token type/ user type.
    3. At page 'Verification Mode', please select [5] for Finger Print Only. Press 'small' to confirm.
      small

  2. If add staff at Software:
    1. See AA-00279 to add new staff at software.

    2. Please tick the Allow 1:N Finger Print Identification checkbox.
    3. Then select Finger Print Only from Verification Mode.
    4. Filled up others necessary field then click OK to save changes.

  3. To enroll finger print template:
    1. See AA-00236 to enroll finger print template.

Custom Fields
  • Summary: This article contains steps to use Verification Mode "Fingerprint Only" for door access.
  • Search Tags: fingerprints only, verification mode, fingerprints, add card
Comments
  • There are no comments for this article.
Submit Feedback on this Article