Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
Wiring connection diagram for XP-M1000x
Author: Microengine Views: 52136 Created: 25-03-2015 05:02 PM 0 Rating/ Voters

This article contains the wiring connection diagram for XP-M1000x. 

Applies To:

  • XP-M1000x, XP-M1000ABX, XP-M1300X, XP-M1300ABX, XP-M1000XE, XP-M1000CPX
 Resolution Summary
 

Configure the wiring connection of the controller according to the wiring diagram provided. Ensure the controller, reader and relay board are supplied with power with 12Vdc, 3A. 

Turn ON the power after complete the wiring connection. Please verify that the MAS-RBU relay board is functional. (Make sure the relay board is producing power)         

 Resolution
 

Please complete the following steps below. 

Refer to the attached wiring diagram at the end of this article for best view. 

Configure the wiring connection according to the following wiring diagram.

FieldConnection to MAS-RBU
Power SupplyConnect Power Supply (12VDC 3A) to terminal +12V and 0v
EM LockConnect to the terminal L/RET and L/NC
  • Thens connect from +12V to L/CM+ and 0V to L/RET 
Door SensorConnect to the terminal D/S and 0V
Push ButtonConnect to the terminal P/B and 0V
DownlinkXP-M1000x to MAS-RBU
  • Step 1: Connect terminal DC+ to the terminal RB+
  • Step 2: Connect terminal DC- to the terminal RB-

Important: Make sure the terminal output from MAS-RBU to lock is producing correct voltage level.

To measure the voltage level at terminal output of MAS-RBU, connect the Multimeter's Red Probe to the L/NC and Black Probe to the L/RET.

1. When door security status is ON, the EM Lock should be in locked condition.
› The voltage measured at terminal L/NC and L/RET showed is about 12V (±10 %)

2. When door security status is OFF, the EM Lock should be in unlocked condition (Door released).
› The voltage measured at terminal L/NC and L/RET approximately +12Vdc (±10 %)

FieldDescription
ReaderConnect the entry/ exit reader to the Entry Reader/ Exit Reader terminal at the back of the controller.

FieldConnection to Controller (XP-M100x)
UplinkUsing Direct Serial Port:

RS232

  • Step 1: Connect uplink cable to port Uplink RS232 (Follow the label)
  • Step 2: Then connect the RS232 cable to the direct serial port at Server PC

RS485 (MCI)

  • Step 1: Connect uplink cable from the MCI to port Uplink RS485 (Follow the label)
  • Step 2: Then connect the MCI cable to the serial port at Server PC

  1. Ensure the jumper J2 is in open condition. 
  2. Please power up the controller after complete the connection.
    1. Make sure the reader is power ON and connected to a power supply with 12Vdc, 3A.

Attachments
m1000x-wiring-diagram.pdf 71.2 Kb Download File
Custom Fields
  • Summary: This article contains the wiring connection diagram for XP-M1000x.
  • Search Tags: wiring diagram xp-m1000x, drawing, xp-m1000x wiring
Comments
  • There are no comments for this article.
Submit Feedback on this Article