Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How do I change the XP-M1000x controller to Card+Pin mode?
Author: Microengine Views: 10167 Created: 25-03-2015 03:21 PM 0 Rating/ Voters

This article contains steps to change the XP-M1000x controller's verification mode to Card+Pin mode. 

Applies To:

  • XP-M1000x
  • XP-M1000ABX
  • XP-M1300X
  • XP-M1300ABX
  • XP-M1000XE
  • XP-M1000CPX
 Problem
 

› I want to change my verification setting using Card+Pin mode when access the door. How to change it?         

         
 Resolution Summary
 

 Enter Programming Mode then enable the Door Parameter menu value (Card+Pin).
› Enabling this menu will require users to key in additional pin after flashing user card to gain access.

         
 Resolution


Enable Card+PIN Mode:

  1. Enter Programming ModeKey in "*" (asterisk) followed by 6 digits Master PIN
  2. Press '1' for Sys menu.
  3. Press '2' for Door Para. Press '#' to proceed to the next item until you find 'Card+Pin' menu.

  4. Change the menu value to 'ON' by pressing '0' to toggle between settings. 
  5. Press '#' to proceed to the next item.
  6. Continue doing this until the Save Changes page is displayed.

  7. Press '#' to save changes and exit from the Door Parameter setting.     



Response in Card+PIN Operation Mode:


Custom Fields
  • Summary: This article contains steps to change the XP-M1000x controller's verification mode to Card+Pin mode.
  • Search Tags: card+pin mode, xp-m1000x, verification mode
Comments
  • There are no comments for this article.
Submit Feedback on this Article