Advanced Search
Search the Knowledgebase
| Author: Microengine Views: 15773 Created: 25-03-2015 02:19 PM | 0 Rating/ Voters |
 |
This article contains steps to change the XP-M1000x as Exit reader while XP-RDPRX as Entry reader.
Applies To:
- XP-M1000x
- XP-M1000ABX
- XP-M1300X
- XP-M1300ABX
- XP-M1000XE
- XP-M1000CPX
- XP-RDPRX
Problem Resolution Summary ResolutionPlease complete the following steps to change the reader setting:
This is the configuration steps to set the XP-M1000x as Exit reader meanwhile the XP-RDPRX as Entry reader.
- Make sure the wiring connection from XP-RDPRX to XP-M1000x is correct.
- Refer Figure 1 below:
Figure 1
Resolution 2:
- Enter Programming Mode. Key in "*" (asterisk) followed by 6 digits Master PIN.
- Press '1' for Sys menu.
- Press '2' for Door Para. Press '#' to proceed to the next item until you find 'As Exit' menu.
- Edit the value to 'YES' by pressing '0' to toggle between settings.
- Press '#' to proceed to the next item.
- Continue doing this until the Save Changes page is displayed.
- Press '#' to save changes and exit from the Door Parameter setting.
» The changes will not be saved if the configuration is interrupted midway.
Custom Fields
- Summary: This article contains steps to change the XP-M1000x as Exit reader while XP-RDPRX as Entry reader.
- Search Tags: xp-rdprx, xp-m1000x, as entry reader, as exit reader
Comments
-
There are no comments for this article.
Submit Feedback on this Article
