Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to reset the XP-M2000i controller to factory default setting? (Coldstart)
Author: Microengine Views: 10803 Created: 23-03-2015 05:47 PM 0 Rating/ Voters

This article contains steps to reset (Coldstart) the XP-M2000i controller to default setting. 

Applies To:

  • XP-M2000i     
 Problem
 

› Controller cannot up. 
 No connection between controller and software.
 No transaction shown at the xPortal software.  
 Forgot predefined controller's IP Address.

         
 Symptoms
 

 At xPortal software, controller status shown down even the connection setup already correct.
 The controller cannot communicate with the software even after configure the network setting, but got pinging reply.

         
 Cause (optional)
 
 IP Address in used is not accessible. 

         
 Resolution Summary
 

 Perform Coldstart to reset the controller to default factory setting.
Warning! Coldstart will reset all setting to default factory settings. All records in the controller also will be deleted. 

         
 Resolution
 

To perform a Coldstart, please follow the steps below:

  1. Make sure the controller is switch on.
  2. Press and hold Reset button. Then Press and hold Coldstart button.
  3. Release the Reset button.
  4. Wait for local Diagnostic LED & Main Fail to light up together. 
  5. The controller will response with 1 long beep sound.

Custom Fields
  • Summary: This article contains steps to reset (Coldstart) the XP-M2000i controller to default setting.
  • Search Tags: coldstart xp-m2000i, reset to default setting, clear all records
Comments
  • There are no comments for this article.
Submit Feedback on this Article