Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to add, delete and change the AutoPIN number when using XP-SR200K?
Author: Microengine Views: 11721 Created: 26-02-2015 03:20 PM 0 Rating/ Voters

This article contains steps to add, delete and change the AutoPIN number using XP-SR200K.

Applies To:

  • XP-SR200KN
  • XP-SR200K  

 Problem
 

› How to add, delete and change the AutoPIN number when using XP-SR200K?   

       
 Resolution Summary
 
Follow steps below:

Resolution 1:
Add AutoPIN

Resolution 2:
Delete AutoPIN

Resolution 3:
Change AutoPIN
 
         
 Resolution
 

Enter to Programming Mode

Add AutoPIN
 Add 1 set of AutoPIN (if it is a new reader).

  1. Press "01" which is 1st set of AutoPIN.
  2. Enter 4 digits AutoPIN number.
  3. Press "#" to confirm.
  4. Press "02" to proceed to add 2nd set of AutoPIN then repeat the Step 1.
  5. To cancel or exit from this operation, press "*".
    » You may add AutoPIN up until 10 sets. Please enter 2 digits number between 01 and 10.



Delete AutoPIN
› Delete 1 set of programmed AutoPIN.

  1. Press the 2 digits number (Between 01 and 10) of the location number of AutoPIN at the keypad button.
    » Eg: 01 = 1st set of AutoPIN
  2. Enter "0000" and press "#" to confirm.
  3. To cancel or exit from this operation, press "*".



Change AutoPIN
› Change 1 set of AutoPIN number.

  1. Refer to the Step Delete AutoPIN above to Delete the programmed AutoPIN.
  2. Press the 2 digits number (Between 01 and 10) of the location number or AutoPIN at the keypad button.
    » Eg: 01 = 1st set of AutoPIN
  3. Enter 4 digits new AutoPIN number and press "#" to confirm.
  4. To cancel or exit from this operation, press "*".
Custom Fields
  • Summary: This article contains steps to add, delete and change the AutoPIN number using XP-SR200K.
  • Search Tags: add autoPIN, delete autoPIN, change autoPIN, xp-sr200k
Comments
  • There are no comments for this article.
Submit Feedback on this Article