Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to program Master Card for XP-SR40?
Author: Microengine Views: 13772 Created: 25-02-2015 11:03 AM 0 Rating/ Voters

This article contains steps to program the Master Card for XP-SR40. 

Applies To:

  • XP-SR40

 Master Card does not work when add new user card or delete user card.
 I lost the 3 Master Cards, what should I do?


 Presenting Master Card to XP-SR40, but the response of the card like normal user card.
 Failed to install new user card/ delete existing user card from XP-SR40 after presenting Master Card.       

 Cause (optional)

 Lost of Master Card.
 Incorrect Master Card is used.
 Master Card was not properly programmed.
 Master Card is yet to be programmed.       

Perform this steps to configure the Master Cards for the first time or re-program the existing Master Cards.
If your programmed Master Cards have been lost, kindly prepared 3 new cards to be program again.

  1. ColdStart the XP-SR40 reader.
    Warning! After ColdStart, the card database in the XP-SR40 will be cleared.
  2. Steps to ColdStart:
    • While turning on the power of XP-SR40, press and hold the exit button for 2 sec.
    • XP-SR40 will keep beeping every 1 sec and the Green LED will be turned on.
    • EM Lock will be released.
  3. Now, XP-SR40 is in the Programming Mode.
  4. Prepare 3 cards and label the cards as the following:
    • Card 1 - Install Card
    • Card 2 - Delete Card
    • Card 3 - Delete All Cards
  5. Present Card 1 to XP-SR40 reader. Then, followed by Card 2 and Card 3. Reader should respond 1 beep when detecting each of the card.
  6. After 3 Master Card are programmed to XP-SR40, 

    1. The Green LED will be turn off.
    2. The reader will stop beeping. 
    3. Now, EM Lock is in engaged condition.

  7. Next: small How to install, delete and clear all cards for XP-SR40?
Custom Fields
  • Summary: This article contains steps to program the Master Card for XP-SR40.
  • Search Tags: program master card, xp-sr40
  • There are no comments for this article.
Submit Feedback on this Article