Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
How to configure "Access Function Enabled/ IO Processor Only" using XP-SNET?
Author: Microengine Views: 13019 Created: 11-11-2015 06:04 PM 0 Rating/ Voters

This article contains steps to configure Operation Mode "Access Function Enabled/ IO Processor Only" using XP-SNET.

Applies To:

  • XP-SNET, XP-SNET v4
  • Software xPortalNet v1.5
 Resolution Summary
 

Please enable this operation mode from the Controller Setup at xPortal Server.

Access Function Enabled/ IO Processor Only:

  1. Prohibited to use any door/ floor access features:
    1.  Such as door, configure/ download door accessibility & floor accessibility, send/ retrieve card settings.

  2. If installed XP-SNET/ XP-SNET v4 is selecting this mode:
    1. Total Door Access will be increased up to 999.

  3. If installed XP-SNET/ XP-SNET v4 is not selecting this mode:
    1. Total Door Access will be back to 255.

       
 Resolution
 

Perform steps below for the above configuration.

  1. Login to xPortalNet Server.
  2. Open Controller Setup. Go to Server Admin › System Device Setup › Controller.
  3. Add one controller. 
  4. At Operation Mode, please select "Access Function Enabled I/O Processor Only".

    This Operation Mode is only applicable for XP-SNET and XP-SNET v4.
  5. Click OK to confirm and save settings.
  6. Following window shall be shown upon saving settings. 
  7. Click Yes to continue.


  8. Refer to small How do I configure Input & Output using XP-SNET controller? (Alarm Monitoring Mode) for full steps to configure XP-SNET Alarm Monitoring.
    Custom Fields
    • Summary: This article contains steps to configure Operation Mode "Access Function Enabled/ IO Processor Only" using XP-SNET.
    • Search Tags: operation, mode, access function enabled, io processor only, xp-snet, xp-snet v4
    Comments
    • There are no comments for this article.
    Submit Feedback on this Article