Knowledge Base

› How to enable AntiPassback settings for single-door controller?   

Perform following steps accordingly.

Step 1: Enabling AntiPassback Function

1. Login to xPortal Client. Make sure controller already up.
2. Open Controller Setup. Go to Data Setup › System Setting › Controller.
3. Following window will be shown.
   
   
   
4. At AntiPassback Function Enabled, select "Yes".
5. At Advanced Controller Setting, you may set following field or leave the default value:
   
   
1. Auto AntiPassback Reset Mode (This field is to specify mode to clear antipassback status automatically)
1. Not Used OR 
2. Reset All Card Holders
   
   
2. Auto AntiPassback Reset Time (This field is to specify time (HH:MM) to execute AntiPassback reset)
1. Set the time to reset the antipassback violation
   
   
6. Click OK to confirm and save changes.
   
   
     Auto AntiPassback Reset Mode & Auto AntiPassback Reset Time applicable to XP-M1000i, XP-M2000i & XP-SNET only 

Multi-Door controller? See  How to enable antipassback settings for multi-door controller?

Step 2: Configure AntiPassback in Staff Records 
*This is applicable to XP-M1000i and XP-M2000i only.

1. Open Staff Records. Go to Data Setup › Access Data Setting › Staff Records.
2. Modify the staff records.
3. Following window will be shown.
   
   
   
4. Toggle the Antipassback field accordingly. This setting will take effect only if antipassback function has been enabled.
   
   
1. Y - To enable the antipassback checking
2. N - To disable the antipassback checking
   
   
5. Click OK to confirm and save the changes.
   

1. Flash card at the reader and observe the transaction. You should get valid access as shown below.
   
   
   
2. Then, try to flash the same card at the same reader. User shall get the following transaction. 
   
   
   
3. The right order to prevent antipassback violation is to flash the card at the entry reader followed by exit reader.
4. If user's card is in AntiPassback state, user will not be able to access the door until the state is cleared. Follow Step 4 below to clear the AntiPB Violation mode.

1. To clear the card from AntiPB Violation mode, download Clear AntiPB setting to the controller. Go to Device Comm › Send Staff Setting › Select controller name › Clear AntiPB.
2. Make a card holder selection or user can just download setting to all card holders by tick All Card.
   
   
   
3. Flash card again and observe the transaction. User should be able to access the door.
4. Finish.