Lift Access Control System

• Configuration Diagram
• AccessPortal XP-CPRO2L Lift Access Control System

The XP-CPRO2L lift access controller can be used to control the access to the levels in the building. It uses the Mio-R16 to control the access to each of the floor. Each card holder is assigned with a floor zone setting which contains the information of how he/she can access to each of the level.

You may configure that the card holder only able to access to a certain levels but denied entry into others.

The XP-CPRO2L lift access control system can be used together with other MicroEngine's door access equipments under the management of a single software system – xPortal2007 or xPortalNet. In this way, the accessibility of the card holder into each of the area including the control inside the lift can be managed from a single point.

back to top

AccessPortal XP-CPRO2L Lift Access Control System
No	Feature	Functions
01	Autonomy	Distributed data and processing
02	Downlink	2 wire RS485
03	No of CDP	2
04	No of floor	64/COP
05	Battery backed real time clock	Yes
06	Onboard rechargeable battery	Yes
07	Card number	6 digits
08	Continuous reads when door left open	Yes
09	Operating modes	Card only
10	Time zones	255
11	Time set	255 each with 3 intervals
12	Holidays	30
13	Onboard Watchdog Circuit	Yes
14	Auto lock release by time zone	Yes
15	Cardholders	10,000
16	Events	20,000
17	RAM memory	At least 128KByte
18	RAM protected by On board battery	Yes
19	Firmware EPROM/flash memory	At least 128KByte
20	Addressing via switch	Yes
21	Onboard buzzer	Yes
22	UCommunication ports	RS485
23	Polarity protection for power connector	4 digits
24	Power	12VDC
25	Relay interface unit	MTR16
26	Reader Interface unit	MK800

back to top