XP-SNet

Knowledge Base
Advanced Search Search the Knowledgebase
Knowledge Base
There are no subcategories in this category.
1 How to configure XP-SNET Lift Floor Access at xPortalNet Client? Featured

This article contains steps to configure the XP-SNET Lift Floor Access at xPortalNet Client.

2 How to configure XP-SNET Lift Floor Access at xPortalNet Server? Featured

This article contains steps to configure the XP-SNET Lift Floor Access at xPortalNet Server.

3 How to reset the reader/ controller to factory default setting? (Coldstart) Featured

This article contains steps to reset the reader/ controller to factory default setting (Coldstart).

4 List of wiring connection diagram for the controllers Featured

This article contains the list of wiring connection diagram for the controllers.

5 Door is not release after received Fire Alarm Signal from the master controller

This article contains steps to solve problem when door is closed after received Fire Alarm Signal.

6 How do I configure Input, Output and Instruction Control? (Alarm Monitoring Mode)

This article contains the steps to configure Input, Output and Instruction Control for Alarm Monitoring mode.

7 How to configure "Access Function Enabled/ IO Processor Only" using XP-SNET?

This article contains steps to configure Operation Mode "Access Function Enabled/ IO Processor Only" using XP-SNET.

8 How to configure 5 Door Access Code in xPortalNet?

This article contains steps to configure 5 Door Access Code using xPortalNet software.

9 How to configure address setting (Unit No) for Multi-Door Controller?

This article contains steps to configure the address setting for Multi-Door Controller.

10 How to configure address setting for XP-SNET reader?

This article contains steps to configure the address setting for Plato readers / XP-MK800 (Reader Interface) on XP-SNET board.

1 2 3 4 Next