Knowledge Base

Knowledge Base
Advanced Search Search the Knowledgebase
 Featured
How to configure XP-SNET Lift Floor Access at xPortalNet Client?
Author: Microengine Views: 21266 Created: 23-03-2015 01:26 PM 100 Rating/ 1 Voters

This article contains steps to configure the XP-SNET Lift Floor Access at xPortalNet Client.

Applies To:

  • Software xPortalNet
  • XP-SNET     
 Problem
 

› How to configure XP-SNET Lift Floor Access at xPortalNet Client?   

       
 Resolution Summary
 
› XP-SNET Lift Floor Access configuration setup in xPortalNet Client:
         
 Resolution
 
This is the steps to configure Lift Floor Access using xPortalNet and XP-SNET. Please complete the following steps:

Setup in xPortalNet Client

  1. Run xPortalNet Client. Make sure the xPortalNet Server is already running and controller is up.
  2. Make sure the setup at xPortal Server already configured. See AA-00300 for the configuration steps.
  3. Configure client setup as shown below accordingly:



Time Set Setup

  1. Open the Time Set Setup. (Go to Data Setup › Access Data Setting › Time Set)
  2. Add new time set.
  3. Click OK to confirm and save the settings.

    » Set the Time Interval for user to access the Lift.
    


Time Zone Setup

  1. Open the Time Zone Setup. (Go to Data Setup › Access Data Setting › Time Zone)
  2. Add new time zone.
  3. Click OK to confirm and save the settings.

    » Select the Time Set on selected day for user to access the lift.



Floor Zone Setup

  1. Open the Floor Zone Setup. (Go to Data Setup › Access Data Setting › Floor Zone)
  2. Add new floor zone.
  3. Specify which floor(s) user can access and which Time Zone will be applied to every Zone #.
  4. Click OK to confirm and save the settings.
  5. Example floor zone setup:

    » TZ selected is as configured at Time Zone Setup above.

    Floor Zone 1 (Ground Floor until Floor 4):


    Floor Zone 2 (Floor 1 and Floor 3):


    Floor Zone 3 (Floor 2 and Floor 4):



Floor Accessibility Setup

  1. Open the Floor Accessibility Setup. (Go to Data Setup › Access Data Setting › Floor Accessibility Setting)
  2. Add new floor accessibility.
  3. Select which Lift user can access and Floor Zone will be applied to every Lift.

    » For this setup, user can only access from Ground Floor until Floor 4 as Floor Zone selected is 003.

  4. Click OK to confirm and save the settings.



Staff Record Setup

  1. Open the Staff Record Setup. (Go to Data Setup › Access Data Setting › Staff Records)
  2. Apply the Door Accessibility and assign the Floor Access Code to the staff.
  3. At Door Accessibility tab, select Use Predefined Settings and choose Free Access.


  4. At General tab, set Floor Access Code for the staff.



  5. Click OK to confirm and save the settings.
  6. You have completed the setup at xPortal Client. 
  7. Flash card to the reader to check and verify the floor accessibility.
Custom Fields
  • Summary: This article contains steps to configure the XP-SNET Lift Floor Access at xPortalNet Client.
  • Search Tags: xp-snet lift floor access, floor zone setup, floor accessibility setup
Comments
  • There are no comments for this article.
Submit Feedback on this Article